We offer a custom parallel encoder replacement for the CRF65-4096G4096C12, accurately replicating the original 4096×4096 multi-turn resolution and parallel output interface. All key mechanical parameters, including shaft diameter, flange dimensions, housing, and connector orientation, are fully preserved, allowing direct plug-and-play installation without modifications. This solution is ideal for customers seeking a reliable replacement to address procurement challenges while maintaining consistent absolute feedback in industrial systems. Production and delivery are completed within 10–15 working days.
This replacement encoder has been successfully adopted in regions including the Middle East, Southeast Asia, Brazil, Russia, and Ukraine. Users appreciate its robust construction, stable multi-turn tracking, and high accuracy under demanding operating conditions. It is suitable for CNC machinery, automated production lines, wind turbines, and material-handling systems, delivering reliable and precise absolute position feedback.
Reference Images
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
